PROJECTA 12V 30A Charger & 35A Power Supply, 30A MPPT Solar Controller BT

R20,039.13(Excl.Vat)

Power management system that builds on the PM300 by adding Bluetooth functionality, allowing the user to operate the system via their smartphone.

 

Out of stock

Bluetooth functionality, allowing the user to operate the system via their smartphone. PM300-BT remote LCD control features battery and charging information (Volts, AMPs, SOC, time remaining), up to 4 water tank level inputs with pump control, a load switch, night mode and silent mode for quiet operation. 14 channel fused output and WAGO terminals, plus a host of protection features and sensors ensure easy, safe operation and monitoring of your electricals.

 

 

Technical Specs

ELECTRICAL
Grid
  Nominal input voltage (V) 240±10%VAC 50/60Hz
  Power factor 0.95
  Input current at full load 2.5A
Battery
  Starter battery 12VDC
  Starter battery voltage range 12.8-16VDC
  Service battery 12VDC
  Service battery voltage range 10.5-16VDC
PV
  Charger type MPPT
  Open circuit voltage 50VDC
  Max supply current 30A
  Max charging current 20A
Charging Relay
  Relay Specification 12VDC 60A continuous, peak current 100A, 30mins
  Connect voltage 13.4V
  Connection delay time 10 sec
  Disconnect voltage 12.8V
  Disconnect delay time 60 sec
  High voltage limit 16.0VDC
  
Charger mode
  Charge Algorithms 5 Stage
  Battery type AGM/GEL/LFP(LiFePO4)/WET
  Start voltage 2V
  Bulk current 20A (Max)
  Absorption voltage (14.4/14.1/14.4/14.7) ±0.15VDC
  Float Voltage (13.5/13.5 /13.5/13.7) ±0.13VDC
Power supply mode
  Nominal output voltage 12.8±0.2 VDC
  Rated output current 35A (Continuous)
Efficiency 88%
Working temperature -40°C~+65°C (50°C: full load; 60°C: 20A; 65°C: shutdown the output)
OTHER
Battery Disconnect (LVD)
  Disconnect voltage 10.5VDC (default) AGM/GEL/WET
11.2 VDC (Default) LiFePO4
  Delay off time 60 sec
  Reconnect voltage 11.5VDC (default) AGM/GEL/WET
12.2 VDC (Default) LiFePO4
Current Draw on Battery
  240VAC is off, no vehicle charging 490mA
  Load Switch Off 255mA 
  LVD off, Service<10.5V current draw on battery 120mA
  Battery switch OFF <10V draw on battery 0mA
Fused outputs
  Numbers 14
  Rated current 15A x 4: 10A x 10
Protection
  Short circuit on output Fuse blown
  Reverse Polarity Diode reverse isolation
  Overload protection Derate the output until overload is removed
  Battery charger over temperature Shut down PM300BT
  Ambient over temperature Alarm
  Battery over voltage limits Battery charger disconnect, loads disconnect
PHYSICAL
  Dimensions (L*W*H) 264x164x128mm
  Weight (kg) 3kgs
  Enclosure Steel case
  Protection category IP20
APPROVALS
  Electrical AS/NZS 60335-2-29
  EMC CISPR14

 

 

Features

• Smart battery charger 12V 35A (20A for charging current)
• Multi stage adaptive charging algorithm
• Active Power Factor Correction (PFC) charging
• Temperature compensation charging
• Voltage compensation charging
• Float Charge for starter battery
• Solar charge controller (MPPT), 30A
• 14 built in fused outputs
• Charging from Alternator at 12V 60A – 60A continuously, 100A 30mins
• Low battery voltage protection
• Built-in battery switch to isolate the battery when in storage
• Built-in shunt for precise battery measurement
• 1 water pump control with up to 4 connections for water sensors
• Thermal control fan
• Spring terminal and screw terminal
• T-bus compatible

 

 

Warranty

2-Year

 

 

Instruction Manual
Intelli-RV Power Management System Range Brochure Brochure